7,241
edits
Changes
Jump to navigation
Jump to search
Line 8:
Line 8: + Line 13:
Line 14: − + + + +
Importing a new version from external source
<br />
<br />
Then adjust the servo limit for the other direction. Drive the tail pitch slider by using the rudder stick to the other maximum endpoint and then release the rudder stick. After a short moment, the color of the Status-LED should start flashing followed by lightning steady purple (mix of red and blue) indicating that the servo endpoint adjustment is complete.<br />
Then adjust the servo limit for the other direction. Drive the tail pitch slider by using the rudder stick to the other maximum endpoint and then release the rudder stick. After a short moment, the color of the Status-LED should start flashing followed by lightning steady purple (mix of red and blue) indicating that the servo endpoint adjustment is complete.<br />
<br />
[[Image:Setupmenu_E_left.png|600px|none|border]]<br />
[[Image:Setupmenu_E_left.png|600px|none|border]]<br />
<br />
<br />
<br />
<br />
[[Image:Warning.png|18px|sub]] If the Status-LED does not light or lights in an unexpected color, the servo throw is obviously too small. In this case mount the linkage ball of the tail linkage rod further inward on the servo horn. This ensures that the tail gyro of MICROBEAST PLUS will perform in the best way and that enough servo resolution is available.<br />
[[Image:Warning.png|18px|sub]] If the Status-LED does not light or lights in an unexpected color, the servo throw is obviously too small. In this case mount the linkage ball of the tail linkage rod further inward on the servo horn. This ensures that the tail gyro of MICROBEAST PLUS will perform in the best way and that enough servo resolution is available.<br />
<br />[[Image:Warning.png|18px|sub]] By (re-)adjusting tail rotor endpoints the servo center trim will be reset to zero (in case it has been changed at [[Manuals:MB_Plus:Parametermenu_A|Parameter menu point '''A''']]).}}<br />
<br />[[Image:Warning.png|18px|sub]] By (re-)adjusting tail rotor endpoints the servo center trim will be reset to zero (in case it has been changed at [[Manuals:MB_Plus:Parametermenu_A|Parameter menu point '''A''']]).}}
<br />
<br />
<br />
----
Push the button to save the configuration and to proceed to [[Manuals:MB_Plus:Setupmenu_F|Setup menu point '''F''']].
Push the button to save the configuration and to proceed to [[Manuals:MB_Plus:Setupmenu_F|Setup menu point '''F''']].
----