Setup menu point F

From BEASTX Wiki
Revision as of 13:12, 12 May 2015 by Shornstein (talk | contribs)
Jump to navigation Jump to search

At Setup menu point F you you have to check if the tail gyro of MICROBEAST PLUS does compensate to the correct direction.

The gyro always tries to steer in the opposite direction of the rotation that is applied to the helicopter. If you move the helicopter by hand around its vertical axis, the gyro must actuate a rudder servo movement to compensate this rotation. If for example you move the nose of the helicopter to the left (tail moving to the right), the gyro has to steer right the same way as you would steer right with the rudder stick, so that the tail is pushed back to the left.




If the gyro does not move the tail rotor to the correct direction you have to reverse the gyro direction. This happens by moving the rudder stick once into any direction. For confirmation you will see that the Status-LED will change its color:

Status-LED Tail gyro direction
red normal
blue reversed


Once again repeat the test as described above. MICROBEAST PLUS should now correct in the right way. Check this function painstakingly as wrong gyro direction will cause the helicopter to spin at very high speed on the vertical axis when trying to takeoff!

Push the button to save the configuration and to proceed to Setup menu point G.