7,227
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: − {{QUOTE|This menu point is only accessible if you have installed the RPM Governor feature on your device and in case you're using a single-line receiver. The RPM Governor function is not applicable when a Standard receiver is used!}}<br />+ + − + Line 23:
Line 24: − +
Importing a new version from external source
{{TOC_MBPlus}}
{{TOC_MBPlus}}
{{DISPLAYTITLE:Setup menu point N|noerror}}
{{DISPLAYTITLE:Setup menu point N|noerror}}
'''This menu point is only accessible if you have installed the RPM Governor feature on your device and in case you're using a [[Manuals:MB_Plus:Receiver_Installation/en#Single-Line_receivers|single-line receiver]]. The RPM Governor function is not applicable when a [[Manuals:MB_Plus:Receiver_Installation/en#Standard_receivers|Standard receiver]] is used!'''<br />
<br />
At Setup menu point '''N''' you can choose between three different options:
At Setup menu point '''N''' you can choose between three different options:
* '''no governor''' - the RPM Governor is not used. All control commands on the throttle channel will be passed to [CH5] output directly.
* '''no governor''' - the RPM Governor is not used. All control commands on the throttle channel will be passed to [CH5] output directly.
* '''electric governor''' - select this option if your helicopter is powered by an electric motor and an electric speed controller is plugged into [CH5] output of MICROBEAST PLUS. MICROBEAST PLUS reads the rpm signal from the speed controller or a phase sensor and controls the rotor speed accordingly. Note that the controller itself must not be operated in a (heli specific) governor mode. The speed controller must process the incomming throttle signals and control the motor as direct and unfiltered as possible (see chapter 2).
* '''electric governor''' - select this option if your helicopter is powered by an electric motor and an electric speed controller is plugged into [CH5] output of MICROBEAST PLUS. MICROBEAST PLUS reads the rpm signal from the speed controller or a phase sensor and controls the rotor speed accordingly. Note that the controller itself must not be operated in a (heli specific) governor mode. The speed controller must process the incomming throttle signals and control the motor as direct and unfiltered as possible.
* '''nitro governor''' - with this option MICROBEAST PLUS can govern the rotor rpm of a helicopter with nitro or gas engine. For this MICROBEAST PLUS controls the throttle servo which is connected to [CH5] output and that controls the carburetor of the engine. The motor rpm will be read from a magnetic or optical sensor that captures the rpm from the crankshaft of the motor, the clutch bell or the main gear.
* '''nitro governor''' - with this option MICROBEAST PLUS can govern the rotor rpm of a helicopter with nitro or gas engine. For this MICROBEAST PLUS controls the throttle servo which is connected to [CH5] output and that controls the carburetor of the engine. The motor rpm will be read from a magnetic or optical sensor that captures the rpm from the crankshaft of the motor, the clutch bell or the main gear.
<br />
<br />
<br />
<br />
----
----
If the RPM Governor is deactivated (option '''no governor''') MICROBEAST PLUS will exit the Setup menu if you briefly press the button. Otherwise pressing the button will lead to [[Manuals:MB_Plus:Governormenu_A|Governor menu point '''A''']]!
If the RPM Governor is deactivated (option '''no governor''') MICROBEAST PLUS will exit the Setup menu if you briefly press the button. Otherwise pressing the button will lead to [[Manuals:MB_Plus:Governormenu_A|Governor menu point '''A''']] (after Menu LED '''N''' now Menu LED '''A''' will flash)!
----
----