Bureaucrats, Administrators, translate-proofr
15,724
edits
Changes
Jump to navigation
Jump to search
Line 57:
Line 57: − + − * Watch the running LED lights during the init phase: If the lights A - G light up the sensor's rest positions are beeing calibrated. H - N show determining the RC channels and their center positions. Initially, the chase is from A - N. If a step is done, the light passes only between A - G or H - N. Can one step not be completed, either the unit is not receiving a valid signal or the MB was moved during the process (e.g. due to wind, vibrations, etc..).+ − <!--T:19--> − * Check whether the receiver sends control signals and that all cables are properly connected to the MICROBEAST. In particular make sure the plugs are inserted with correct polarity and not offset to the pin connectors of the MICROBEAST. − <!--T:20-->+ − + + + + + + + + +
no edit summary
==Startup== <!--T:17-->
==Startup== <!--T:17-->
===MICROBEAST does not finish initialization. What can I do?=== <!--T:18-->
===MICROBEAST does not finish initialization. What can I do?===
Watch the running LED lights during the init phase: If the lights A - G light up the sensor's rest positions are beeing calibrated, H - N show determining the RC channels and their center positions. Initially, the chase is from A - N. If one step is done the indication light for this step will quit running.
When LEDs A - G do not quit running
* Only applies to Microbeast with firmware V2.0.0 and up: Is the correct type of receiver selected in the receiver setup menu? See [[Setup receiver type - Microbeast, Trajectory]]
* The sensors register movement and calibration of rest position can not be finished. Make sure the unit/the helicopter does not get moved e.g. by wind gusts or people leaning on your work bench.
When LEDs H - N do not quit running
* All MICROBEAST/MICROBEAST PLUS: Check whether the receiver sends out control signals and that all cables are properly connected to the MICROBEAST. In particular make sure the plugs are inserted with correct polarity and not offset to the pin connectors of the MICROBEAST.
* MICROBEAST/MICROBEAST PLUS Version 2.0.0 and greater: Is the correct type of receiver selected in the receiver setup menu? See [[Setup receiver type - Microbeast, Trajectory]]
* AR7200BX: Check binding between transmitter and unit.
===The brand new MICROBEAST only shows a red flashing LED or even nothing. What's wrong?=== <!--T:21-->
===The brand new MICROBEAST only shows a red flashing LED or even nothing. What's wrong?=== <!--T:21-->