Bureaucrats, Administrators, translate-proofr
15,724
edits
Changes
Jump to navigation
Jump to search
Line 1:
Line 1: + Line 5:
Line 6: + − + Line 34:
Line 36: − +
Marked this version for translation
<translate>
<translate>
<!--T:1-->
{{DISPLAYTITLE:Receiver Menu Point A|noerror}}
{{DISPLAYTITLE:Receiver Menu Point A|noerror}}
{{TOC_MBPlusV5|Manuals:MBPlusFblV52:ReceiverType/en|Manuals:MBPlusFblV52:Receiver_B/en||2}}
{{TOC_MBPlusV5|Manuals:MBPlusFblV52:ReceiverType/en|Manuals:MBPlusFblV52:Receiver_B/en||2}}
<br />
<br />
<!--T:2-->
{{WARNING_QUOTE|In case you are using a single-line receiver, note that in the first menu points of Receiver Menu no control signal is emitted on the throttle output([CH5] or [DI1]). Only at Menu Point '''N''' (Throttle failsafe setting) the output will be activated to check throttle position! '''If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the motor!''' For a heli with combustion engine you should remove the servo horn from the throttle servo to avoid linkage binding or breaking the servo horn.}}<br />
{{WARNING_QUOTE|In case you are using a single-line receiver, note that in the first menu points of Receiver Menu no control signal is emitted on the throttle output([CH5] or [DI1]). Only at Menu Point '''N''' (Throttle failsafe setting) the output will be activated to check throttle position! '''If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the motor!''' For a heli with combustion engine you should remove the servo horn from the throttle servo to avoid linkage binding or breaking the servo horn.}}<br />
=Adjustment on the device=
=Adjustment on the device= <!--T:3-->
To get into the Receiver menu press the button on MICROBEAST PLUS and hold it down before(!) and while turning on the receiver power supply. The yellow Menu LEDs start to cycle immediately. When you release the button, Menu LED '''A''' will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.<br />
To get into the Receiver menu press the button on MICROBEAST PLUS and hold it down before(!) and while turning on the receiver power supply. The yellow Menu LEDs start to cycle immediately. When you release the button, Menu LED '''A''' will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.<br />
<br />
<br />
{{NL}}
{{NL}}
=Setup with StudioX=
=Setup with StudioX= <!--T:4-->
When StudioX is started and your MICROBEAST PLUS is connected with StudioX, click the '''Control Setup''' button to show the adjustment options of RECEIVER MENU.<br />
When StudioX is started and your MICROBEAST PLUS is connected with StudioX, click the '''Control Setup''' button to show the adjustment options of RECEIVER MENU.<br />
* At the top of the screen you can see which type of input signal is selected at the moment, and which telemetry system/ESC is used (if applicable).
* At the top of the screen you can see which type of input signal is selected at the moment, and which telemetry system/ESC is used (if applicable).