7,593
edits
Changes
Jump to navigation
Jump to search
Translations:Manuals:BXFbl:Radio Setup:SRXL2/4/en (view source)
Revision as of 14:27, 9 April 2024
, 2 months agoImporting a new version from external source
For bi-directional telemetry connect the SRXL2 signal wire either to the SYS port or to the DI2 port of your MICROBEAST PLUS / ULTRA. When using the DI2 port an adapter from standard servo connector to 5-pin JST is required as shown below. Or you can use the original 4-pin wire that comes with your SPEKTRUM® receiver. In this case please note the the wire must be modified as shown below!<br />
<br />
<br />