Changes

'''MICROBEAST ULTRA'''<br />

'''MICROBEAST ULTRA (v5.9.x)'''<br />

* Disconnect(!) the Spektrum® remote satellite and switch on the power supply.

* Disconnect(!) the Spektrum® remote satellite

* During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release

* To bind a DSMX satellite switch on the power supply now. The yellow LED '''A''' on the MICROBEAST ULTRA will start to flash. Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash as well. Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).

* LEDs A and H flash in alternating sequence

* After successful binding procedure the receiver‘s LED will stay solid. Then the device will restart and enter RECEIVER MENU if the current receiver type is not set to DSMX or will start with init sequence. Remove the bind plug and proceed.

* Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST

* Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).

* After successful binding procedure the receiver‘s LED will stay solid

* Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed.

<br />

<br />

<br />

<br />