7,558
edits
Changes
Jump to navigation
Jump to search
Line 60:
Line 60: − + − * Insert a Spektrum® ''Bind Plug'' at the '''[AUX|PIT|RUD]''' port.+ − + − * To bind a DSMX satellite switch on the power supply now. The yellow LED '''A''' on the MICROBEAST ULTRA will start to flash. Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash as well. Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).+ − + + + + − <br /> − − <gallery mode="nolines"> − File:DSMXbind MB ULTRA 1.jpg|You need: RX, bind plug and battery − File:DSMXbind MB ULTRA 2.jpg|Connect bind plug at [AUX-PIT-RUD] − File:DSMXbind MB ULTRA 3.jpg|Power up MICROBEAST: LED A flashes − File:DSMXbind MB ULTRA 4.jpg|Connect RX at [DI2] - it will also flash − File:DSMXbind MB ULTRA 5.jpg|Start bind sequence on radio − File:DSMXbind MB ULTRA 6.jpg|Bind successful − File:DSMXbind MB ULTRA 7.jpg|Proceed with setup − </gallery>
Manuals:BXFbl:Radio Setup:RemoteSat/en (view source)
Revision as of 18:39, 30 May 2024
, 23 days agoUpdating to match new version of source page
<br />
<br />
'''MICROBEAST ULTRA'''<br />
'''MICROBEAST ULTRA (v5.9.x)'''<br />
* Disconnect(!) the Spektrum® remote satellite and switch on the power supply.
* Disconnect(!) the Spektrum® remote satellite
* During init sequence (LED light H-N is running) push and hold the button for 4 seconds, then release
* LEDs A and H flash in alternating sequence
* After successful binding procedure the receiver‘s LED will stay solid. Then the device will restart and enter RECEIVER MENU if the current receiver type is not set to DSMX or will start with init sequence. Remove the bind plug and proceed.
* Now connect your remote satellite to the pin board. The receiver's yellow LED will start to flash in combination with LED A on MICROBEAST
* Now you can bind the transmitter as usual (for more information refer to the instructions of your radio control system).
* After successful binding procedure the receiver‘s LED will stay solid
* Your MICROBEAST will restart and enter RECEIVER MENU. Press button briefly to scan for the receiver and proceed.
<br />
<br />
<br />
<br />