7,615
edits
Changes
Jump to navigation
Jump to search
Line 34:
Line 34: + + + + +
Updating to match new version of source page
|[[File:Basic_setup_swashplate_adcvance.PNG|x200px]]
|[[File:Basic_setup_swashplate_adcvance.PNG|x200px]]
|}<br />
|}<br />
<br />
==Additional swashplate servo for scale helicopters==
When using a scale helicopter with 90 degrees eCCPM, you can connect a second elevator servo to [CH7] output on the MICROBEAST PLUS. On MICROBEAST ULTRA the second elevator servo connects to [CH6]. Please note that the second elevator servo port will require a power cycle to enable after you've set up 90 degrees eCCPM mode. You can also change the ratio for the servo at [CH6] / [CH7] in StudioX to activate the additional servo output. When the ratio for [CH6] / [CH7] is 0 on the other hand, the servo outputs will be controlled from the AUX channel that can be set in RECEIVER MENU.<br />
<br />
<br />
<br />