Bureaucrats, Administrators, translate-proofr
15,724
edits
Changes
Jump to navigation
Jump to search
Line 16:
Line 16: − If the driver installation fails, you may see an error message with a red cross next to the device icon: − [[File:Driver failed.png|200px|thumb|none]] − In this case further steps are necessary to perform. Otherwise you can start to use StudioX. + + + + + − After successful installation of the driver, when the USB2SYS-Interface is connected to the PC, you must be able to find following entry in the Windwos Device Manager:+ + + + Line 32:
Line 37: − + + − To access the device manager under windows 7 type devmgmt.msc in the Startmenu's search bar. Alternatively you can enter the computer properties by pressing and holding the START key on the keyboard and addtionaly pressing the PAUSE key. Then click on device manager in the upper left corner of the appearing window.+
no edit summary
File:Driver success.png
File:Driver success.png
</gallery>
</gallery>
<br />
<br />
<!--T:7-->
<!--T:7-->
'''2. Validate driver installation'''
'''2. Validate driver installation'''
If the driver installation fails, you may see an error message with a red cross next to the device icon:
[[File:Driver failed.png|200px|thumb|none]]
<br />
In this case you have to install the driver files manually which will be described in the following step 3.<br />
<br />
<!--T:48-->
<!--T:48-->
If you did not see any message popping up at all, check you Windows device manager if the USB2SYS has been installed correctly. To access the device manager under windows 7 type devmgmt.msc in the Startmenu's search bar. Alternatively you can enter the computer properties by pressing and holding the START key on the keyboard and addtionaly pressing the PAUSE key. Then click on device manager in the upper left corner of the appearing window.
[[File:Device mgr.png|200px|thumb|none]]
<br />
You must be able to find following entry:
<!--T:8-->
<!--T:8-->
<!--T:9-->
<!--T:9-->
<br />
<br />
The name COM3 may be different on your PC. This entry must disappear when you disconnect the USB2SYS-Interface from the PC, and reappear when you connect it again.
The name COM3 may be different on your PC. This entry must disappear when you disconnect the USB2SYS-Interface from the PC and re-appear when you connect it again.
If there is only an entry marked with an yellow "!" something went wrong and you have to install the driver files manually which will be described in the following step 3.
<!--T:10-->
<!--T:10-->
'''4. Manual installation of USB2SYS interface driver'''