Changes

<br />

<br />

===Transmitter setup (endpoint adjustment)===

===Einstellung des Sender (Endpunktanpassung)===

Before you can use your Castle Creations ESC you must adjust your transmitters throttle range so that it'll fit to the ESC's throttle range. Later onwards we will also set this throttle range at the MICROBEAST PLUS unit.

Bevor der Castle Steller in Betrieb genommen werden kann, müssen die Gas-Endpunkte im Sender an die Vorgabe durch den Steller angepasst werden. Später werden diese Endpunkte dann auch im MICROBEAST PLUS einprogrammiert.

(1) First of all make sure you have a standard linear throttle curve from 0 - 100% in your transmitter and that your servo endpoints are reaching from -100% to +100%. In this example we're using a Spektrum DX9, for your transmitter these values maybe somehow different. Basically what you need is a standard throttle control as you get when using a new model memory in the transmitter. Make sure you can control the throttle by watching the throttle channel movement on the transmitter's servo monitor.<br />

(1) First of all make sure you have a standard linear throttle curve from 0 - 100% in your transmitter and that your servo endpoints are reaching from -100% to +100%. In this example we're using a Spektrum DX9, for your transmitter these values maybe somehow different. Basically what you need is a standard throttle control as you get when using a new model memory in the transmitter. Make sure you can control the throttle by watching the throttle channel movement on the transmitter's servo monitor.<br />