Importing a new version from external source
* '''Standard receiver''' is any receiver that is connected to MICROBEAST PLUS using the standard servo output ports on the receiver and connecting these to the function input ports on MICROBEAST PLUS using the five connection cables. Also see the topic [[Manuals:MB_Plus:Receiver_setup_intro|Receiver installation]].
* Choose '''Single Spektrum® satellite''' only when you have connected one single Spektrum® remote satellite directly to the [DI1] port of MICROBEAST PLUS using the optional available
Spektrum® satellite adapter (Order Nr. BXA76009). If using a conventional Spektrum® receiver that is connected with multiple wires to MICROBEAST PLUS please select option '''Standard receiver'''.
* When using the S-Bus signal of a '''Futaba® S-BUS''' receiver make sure the signal output of the receiver is setup correctly. Newer Futaba® receivers allow to configure the signal outputs differently and also may have different ports for S-Bus2 and S-Bus1. In this case make sure to use the S-Bus1 signal!
* '''SRXL''' is a data format that is used by different manufacturers of radio systems and that is sometimes designated differently. Please see [[SRXL_-_Serial_Receiver_Link_protocol/en|this site]] for further information. Choose '''SRXL''' when using the single-line signal of one of the following receivers: JETI receivers with UDI serial output mode (not PPM), JR receivers with XBUS Mode B output, Multiplex M-Link receivers with SRXL output, BEASTRX receivers with SRXL output, GRAUPNER HOTT receivers with SUMD output (not SUMO!), Spektrum AR9020 receivers with SRXL output (only with special MICROBEAST PLUS firmware!)