7,227
edits
Changes
Jump to navigation
Jump to search
Line 53:
Line 53: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
Updating to match new version of source page
<br />
<br />
'''When the device does not appear once again check driver installation and port configuration as shown above.'''<br />
'''When the device does not appear once again check driver installation and port configuration as shown above.'''<br />
<br />
<br />
{|
|width = "400pt" style= "padding: 0px 50px;" | [[File:USB2SYS_MBPlus.png|400px|none]]
|-
|style= "font-size: x-small; padding: 10px 50px;" align = "center"| All BEASTX gyros come with a serial communication port which typically is marked with the letters ''SYS''. Connect the servo wire coming from your USB interface to this port. Make sure to connect the wire in correct polarity on both sides! When using the USB2SYS interface you have to power the device with a separate power supply, i.e. receiver battery or BEC of the R/C model. It will not be powered from the USB port.
|}
<br />
Also you can use a RX2SIM Wireless Multi-Sim Adapter instead of the USB2SYS interface. For this you can switch the RX2SIM into an USB2SYS emulation mode (push button on the RX2SIM several times until the LED lights up in orange color).<br />
<br />
<table>
<tr>
<td width = "400pt" style= "padding: 0px 50px;">[[File:RX2SIM_MBPlus.png|400px]]</td>
<td width = "400pt" style= "padding: 0px 50px;">[[File:RX2SIM_MBPlus_powered.png|400px]]</td>
</tr>
<tr>
<td style= "font-size: x-small; padding: 10px 50px;">In this configuration the BEASTX gyro will be powered from the USB port. Anyhow, this only will work when receiver and servos are not connected to the gyro! Otherwise the power of the USB port will not be sufficient to supply all consumers. In this case you have to power the device from the receiver battery as well.</td>
<td style= "font-size: x-small; padding: 10px 50px;">But here when using more than 6 Volts (i. e. using a 2s Lipo battery as receiver power supply) you must disconnect the red wire (plus pole) from the servo wire going to the interface. '''Otherwise you will damage the RX2SIM and/or USB port of your computer!'''</td>
</tr>
</table><br />
<br />
To configure and update your BLE2SYS bluetooth LE adapter with StudioX connect it with the USB2SYS interface or RX2SIM wireless simulator interface to the computer. Using the USB2SYS you must power the device with an external power supply connected to a Y-harness. Watch out for correct polarity!<br />
<br />
<table>
<tr>
<td style= "padding: 0px 50px;">[[File:BLE2SYS_to_USB2SYS.png|x150px]]</td>
<td style= "padding: 0px 50px;">[[File:BLE2SYS_to_RX2SIM.png|x130px]]</td>
</tr>
</table>
<br />
<br />
<br />
<br />
<br />