Translations:Manuals:BXFbl:Setupmenu E/3/en
Jump to navigation
Jump to search
Mechanical setup of the rudder servo
In the following of this setup step you will be asked to connect the rudder servo to your BEASTX device. With MICROBEAST PLUS/ULTRA the servo connects to [CH4] output. Watch out for correct polarity, the black or brown minus wire must be the clostest to the bottom of the device. Using NANOBEAST please connect the servo to [CH2] output. Here the servo polarity is similar to SPEKTRUM/Horizon Hobby servos, from inside to outside: signal, minus, plus.
