Translations:Manuals:MBPlusFblV52:Receiver M/20/en
Jump to navigation
Jump to search
OMP 65A ESC
Connect the control wire of your OMP ESC to port [DI1]. Connect the pin labeled with "TX" from the ESC to the port [CH5] using a single servo wire with plugs on both sides. Optionaly you can connect the yellow wire for measuring the motor speed to the [RPM] input at MICROBEAST PLUS, so that it is out of the way. For telemetry transmission it is not needed as the data will be included in the telemetry signal!
Make sure the ESC is sending data with OMP telemetry data protocol. This is the factory setting of the ESC. Do not change the protocol to "SBUS2" or other! MICROBEAST PLUS will convert the data into your radio's protocol as needed.