Translations:Manuals:MBUltraFblV5:BankSwitch/6/en

Setup with StudioX app

When StudioX has connected to your MICROBEAST ULTRA, click the Parameter button from the overview screen. In parameter view click the "Next" (->) button repeatedly, until you reach the screen Bank 1 - Gains or directly go to this options screen using the box on top. Here you can activate Bank Switching by clicking the specific button above the gain adjustments. When Bank switching is activated, the following screens are accessible and can be used to change parameters for each of the Banks 2 & 3 besides the parameters of Bank 1 in the beginning.

• Please note that the first screen "Quick trim" has global effect, meaning that the values are used in all of the Banks. Separate trimming for each bank is not provided.
• By default the gain settings for each bank correspond to the default position of the dials. The tail gain must be taken from the gain value that is shown on the StudioX main screen, in case you've already flown the heli without bank switching. If starting directly using bank switching, we'd recommend to set the Tail Gain to 50 and readjust the gain as needed. See section about the Tail gyro for further information.
• The default values are shown in braces for some parameters. If you like to know the values behind the Control Style parameter, click on the advanced view tab. Here you can see which numbers are set at a given control style.
• We recommend to created a Backup of your settings before making any adjustments. So you can easily change back to your initial setting, in case you're not satisfied with your new settings. Also we'd recommend to not change to much parameters at once and to increase/decrease settings only in small steps.
• When you've set a separate control channel for the AttitudeControl function in Control setup menu, the gain adjustment for AttitudeControl in the app will have no effect. Only you can use Bank Switching to change between different rescue modes in flight, but the gain is not adjustable by app. On the other hand when you did not assign a separate channel for the AttitudeControl, you can set the AttitudeControl gain for each bank/flight mode and use the Banks/flight modes to activate/deactivate the rescue in flight. Here AttitudeControl will enable when the gain is higher than 12! Check the status display on the device overview main screen or the display on the device to see if AttitudeControl is active and what gain is set!