Governor setup menu point D

Instruction manual

1. Introduction

2. Box content and accessories

3. MICROBEAST PLUS HD

4. Preliminary steps

5. Receiver installation

6. Optional features explanation

7. Receiver setup menu

A - Receiver type (signal input)

B - Channel to function assignment

N - Throttle failsafe position

8. Setup menu

A - Device orientation

B - Swashplate update rate

C - Rudder servo center pulse

D - Rudder servo update rate

E - Rudder servo limits

F - Tail gyro direction

G - Swashplate servo trim

H - Swashplate mixing type

I - Swashplate servo directions

J - Swashplate servo throw

K - Collective pitch

L - Swashplate servo limit

M - Swashplate gyro directions

N - Internal RPM Governor

9. Parameter menu

A - Quick trim

B - Control style

C - Speed flight stability

D - Rudder rate consistency

E - Stick deadzone

F - Torque precompensation

G - Cyclic response

H - Pitch boost

I - Throttle response

J - Slow rampup speed

K - Fast rampup speed

L - AttitudeControl mode

M - AttitudeControl pitch

10. Governor setup menu

A - Test mode

B - Throttle low position

C - Throttle high position

D - Transmitter setup

E - Signal divider

F|G|H - Main gear ratio

11. Flying and optimization

12. Usage of RPM Governor (optional)

13. Usage of AttitudeControl (optional)

Download PDF

Similar to menu point A, menu point D only serves to give you some status information. At menu point D the different activation points of the RPM Governor will be displayed based on color and state of the Status-LED. So you can prepare your transmitter for use with the RPM Governor function. The information conveyed by the Status-LED is basically the same in every Governor operation mode. However, the setup of the transmitter will be slightly different, depending on whether the mode electric or nitro is used.

Governor setup menu point D

Navigation menu

Search