Translations:StudioXm:Overview/16/en

Overview screen

When connection to your BEASTX device is established, wait until the data is loaded from the device and initialization sequence is finished. At first the system will calibrate to the radio system. Menu LEDs H to N will cycle up and down on MICROBEAST PLUS/MICROBEAST ULTRA. With NANOBEAST the Status LED will flash slowly in red color. You can read Radio init in the opening overview screen of StudioX. During this time do not move the sticks on your radio as the system is learning the stick mid positions!

In the second step the device checks if the sensors are working correctly and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down on MICROBEAST PLUS/MICROBEAST ULTRA. With NANOBEAST the Status LED will constantly light in red color. You can read Sensor init in the opening overview screen of StudioX. During this time do not move the helicopter!

When initialization is completed, the Status LED will change to blue or purple color indicating the current gyro mode and you can read the gyro gain and mode in the app.

To be able to access all settings wait until your device has passed initialization sequence. If it doesn't, probably receiver setting is wrong. So start with the CONTROL SETUP.

If you can't get through the initialization sequence either because LEDs A-G or LEDs H-N don't stop cycling, please read the FAQ and do the CONTROL SETUP first (see manual of your device for further instructions).