Translations:Help:FAQ/33/en

From BEASTX Wiki
Jump to navigation Jump to search

The presets at Parameter menu point B are nothing else than different preset DualRate/expo curves inside MICROBEAST / MICROBEAST PLUS making the heli rotate slower or faster at a given stick input and making the stick contol more or less sensitive around stick center position. Choose the preset that fits your preferences best and that gives you a good amount of rotation rate. Using the presets (except for the "Transmitter" preset) it is recommended to not change the output signal in the TX significantly as especially when using expo this will bend, compress or stretch the internal curves, leading to very strange flight behavior (anyhow, doing small adjustments in stick throw, i.e. for slightly increasing the roll rate should work without any issues).

If you want to create your own control style easiest thing to do would be to switch Parameter menu point B to preset blue (="Transmitter") and adjust the curves in your transmitter just as you like. Therefor we suggest to start with a setting of 70% D/R and 25% expo on cyclic and 85% D/R and 40% expo on tail in the transmitter and adjust the curves accordingly. When setting parameter B to "blue = TX" the internal curves in MICROBEAST will be "disabled". Here 100% stick input will give a rotation rate of apprx. 600deg/s on the rudder axis and apprx. 300 deg/s for the cyclic movements (this may vary depending on TX brand as any manufacturer use another signal output as maximum, so this also can be 107, 110% or 95%).

We are often asked which percentages of expo or dual rate corresponds to the different presets. As manufacturers calculate expo curves different, we can't tell you what our preset curves correspond to which TXs expo values as we use our own expo calculation and there is no data available for comparing. We did out fly these values and programmed them in the source code so we can't tell what these are in Futaba or JR percentages. If you want to use a specific preset as your starting point we suggest to connect your MICROBEAST to the StudioX software. Here you can see the different values for each control behavior preset and you can save a custom preset for which you may use the given values and adjust them with StudioX until they perfectly fit your flying style.