Changes

  '''Note for MICROBEAST/Ar7200BX/Ar7200BX:''' If Parameter menu point B is set to preset "blue" and the tail

  '''Note for MICROBEAST/Ar7200BX/Ar7200BX:'''

gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail

If Parameter menu point B is set to preset "blue" and the tail gain is switched to heading lock mode you can see in operation mode by the Status LED state at which tail

  stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick

  stick position the maximum possible rotation rate on rudder will be reached: At that specific tail stick position the Status LED will start to flash. Moving the stick

position the Status LED will start to flash. Moving the stick to this point in flight the rotation rate of

to this point in flight the rotation rate of the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go off. At this  

the helicopter will be as high as the gyro can control. Increasing the stick throw further the LED will go

point the rate control is switched off and the tail will spin freely. Here the only limit is the tail pitch throw and normaly the tail will spin ultra  

off. At this point the rate control is switched off and the tail will spin freely. Here the only limit is

fast. This can be used for performing tail slides or turns with very fast spinning tail. For normal flying around you should not use this as you may  

the tail pitch throw and normaly the tail will spin ultra fast. This can be used for performing tail slides

  accidentaly steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground that the Status LED will not go off when giving  

or turns with very fast spinning tail. For normal flying around you should not use this as you may accidentaly

full rudder stick deflection in your default flight modes.

  steer into the uncontrolled area and the tail may spin too fast or very uneven. So please check on the ground

that the Status LED will not go off when giving full rudder stick deflection in your default flight modes.