Translations:Help:StudioX/9/en

From BEASTX Wiki
Revision as of 22:31, 14 June 2019 by FuzzyBot (talk | contribs) (Importing a new version from external source)
Jump to navigation Jump to search

StudioXm (StudioX 3) does not recognize my device

I'm sure I have selected the correct interface port but StudioX scans for some time and than says no device found.

  • Make sure the wiring is connected correctly. The servo wire coming from the USB interface goes into SYS port on your MICROBEAST PLUS / AR7210BX. Watch out for correct polarity and make sure that the device is powered from a receiver battery or BEC (only when using the RX2SIM interface the BEASTX device can be powered from the USB port!).
  • When using a smartphone the BLE2SYS interface must be connected to the SYS port, watch out for correct polarity. Make sure the LED on the BLE2SYS flashes in intervals of 2 seconds. By default the interface deactivates after 30 seconds whe there is no connection. In this case the LED is off. You have to cylce power in order to reactivate the device.