Translations:MICROBEAST PLUS RPM Governor - How to setup a Castle Creations ESC/16/en

From BEASTX Wiki
Revision as of 15:46, 30 March 2022 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

"External Governor" mode

With MICROBEAST PLUS / AR7210BX Firmware Version 4.2.x or higher it is possible to use the "External Governor" mode of your Castle Creations ESC. This will allow to let the ESC do the initial rotor spool up as well as the quick spool up after an auto rotation maneuver. You will have a softer motor start/less motor torque than when powering up the motor in "Fixed wing" mode, as this is optimzed for turning air screws. For this purpose you must disable the soft start feature of MICROBEAST PLUS / AR7210BX which can be done using the Expert Parameter tab in StudioX. Basically the setup procedure is very similar as already shown above, just you need to change a few parameters by software:

Choose "External Governor" mode in Castle Link Software and don't forget to enable autorotation bail out. Rest is same as shown above in the very beginning.
Disable Softstart of MICROBEAST PLUS / AR7210BX with StudioX.

Proceed as described above:

  • First define throttle endpoints in the transmitter. This must be done even if you've done it already before in "Fixed wing" or "Multirotor" mode, as in "External Governor" the endpoints will be slightly different!
  • Open RECEIVER MENU, assign functions and set the low throttle failsafe position in case your low throttle value changed in the transmitter.
  • Finally do the complete Governor Setup or at least teach new throttle low and high point to MICROBEAST PLUS / AR7210BX if the Governor mode was already in use before.
Retrieved from "https://wiki.beastx.com/index.php?title=Translations:MICROBEAST_PLUS_RPM_Governor_-_How_to_setup_a_Castle_Creations_ESC/16/en&oldid=19335"