Translations:Manuals:AR7210FblV5:Governor/5/en
Jump to navigation
Jump to search
Electric drive system with rpm signal output from the speed controller
When a speed controller is used that provides a rpm signal output you can directly plug the sensor wire from the ESC into the AX2/RPM input on the AR7210BX. In case the speed signal wire also has power lines watch our for correct polarity. The signal wire must be on top, the minus wire is connected at the bottom of the AR7210BX pin board. In case your speed controller doesn't come with power lines and only has one wire instead, make sure this wire is connected at the top of the device. The speed controller‘s control signal input is plugged into the throttle output [THRO] as usual.