Translations:Manuals:BXFbl:Receiver A/4/en

From BEASTX Wiki
Jump to navigation Jump to search

MICROBEAST PLUS / ULTRA

To get into the RECEIVER MENU press the button on MICROBEAST PLUS/ ULTRA and hold it down before(!) and while turning on the receiver power supply. The yellow Menu LEDs start to cycle immediately. When you release the button, Menu LED A will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.



In order to detect the receiver you're using, make sure the receiver is connected properly, bound to the radio and sending out signals. Also make sure the transmitter is setup correctly. Then briefly press the button to start automatic receiver detection routine. The Status LED will indicate the scan process:

Status-LED Receiver type/protocol
off Standard receiver
purple Receiver at remote port
red No receiver detected
blue Receiver at front port