Latest revision as of 11:41, 24 April 2024
Information about message (contribute ) This message has no documentation.
If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:BXFbl:Setupmenu C )
At Setup menu point '''C''' you can change the pulse with of the rudder servo channel. Usually servos use a pulse width of 1500 to 1520 µs to move to center position, 1000 µs to move to one side and 2000 µs to move to the other. In order to speed things up some engineers had the idea of reducing the pulse, so you can send more pulses and thus more control commands to the servos within a given time. Especially on the rudder this can be useful to increase gyro performance. So some manufacturers released special rudder gyro servos with a reduced pulse of 760µs (half of the usual pulse width). And then there were others that invented servos with center at 960µs which is not so common nowadays. No matter which servo you're using, with BEASTX you can use any of them.<br />
At Setup menu point '''C''' you can change the pulse with of the rudder servo channel. Usually servos use a pulse width of 1500 to 1520 µs to move to center position, 1000 µs to move to one side and 2000 µs to move to the other. In order to speed things up some engineers had the idea of reducing the pulse, so you can send more pulses and thus more control commands to the servos within a given time. Especially on the rudder this can be useful to increase gyro performance. So some manufacturers released special rudder gyro servos with a reduced pulse of 760µs (half of the usual pulse width). And then there were others that invented servos with center at 960µs which is not so common nowadays. No matter which servo you're using, with BEASTX you can use any of them.<br />
<br /> Translation At Setup menu point '''C''' you can change the pulse with of the rudder servo channel. Usually servos use a pulse width of 1500 to 1520 µs to move to center position, 1000 µs to move to one side and 2000 µs to move to the other. In order to speed things up some engineers had the idea of reducing the pulse, so you can send more pulses and thus more control commands to the servos within a given time. Especially on the rudder this can be useful to increase gyro performance. So some manufacturers released special rudder gyro servos with a reduced pulse of 760µs (half of the usual pulse width). And then there were others that invented servos with center at 960µs which is not so common nowadays. No matter which servo you're using, with BEASTX you can use any of them.<br /> At Setup menu point C you can change the pulse with of the rudder servo channel. Usually servos use a pulse width of 1500 to 1520 µs to move to center position, 1000 µs to move to one side and 2000 µs to move to the other. In order to speed things up some engineers had the idea of reducing the pulse, so you can send more pulses and thus more control commands to the servos within a given time. Especially on the rudder this can be useful to increase gyro performance. So some manufacturers released special rudder gyro servos with a reduced pulse of 760µs (half of the usual pulse width). And then there were others that invented servos with center at 960µs which is not so common nowadays. No matter which servo you're using, with BEASTX you can use any of them.