Translations:Manuals:MBPlusFblV52:Receiver B/8/en

Manual function assignment

In case the channel to function ordering differs from the given setting, you have to manually assign the channel order step by step. This is done by simply actuating the appropriate channel function on your transmitter at each of the Menu Points B to I (J for devices with AttitudeControl/rescue). Each menu point represents one control function to assign. When you're ready click Teach in the "New receiver detected!" dialog and start with function allocation at Menu Point B.

• When you move the control stick/change the channel output on the transmitter, the Status LED will flash when the channel has been detected and the channel number will appear in the display. The setup will jump to the next function assignment automatically.
• It is important that only one channel moves on the radio whe the requested function is activated. Otherwise MICROBEAST PLUS can't recognize the desired channel. The Status LED will not flash in this case!
• Once a channel was assigned, it is no longer available and is ignored by MICROBEAST PLUS for the remaining process. After learning of the collective pitch function (at Menu Point B) you can enable the throttle function (remove throttle hold) to teach the throttle channel at Menu Point G with the thrust stick. The collective pitch channel will no longer be considered as this channel has been assigned already.
  

Choose Teach

At first move the stick for collective. Make sure only one channel is moved on the radio otherwise MICROBEAST PLUS is not able to detect the movement!

Proceed with the other function in similar manner

The optional functions can be skipped if not needed. See text below!

When skipping the channel number will be shown as -

The first 6 functions must be assigned as theses are necessary for the basic flight control. The other functions are optional and can be skipped. If special features like AttitudeControl or Headspeed Governor are not installed on your device, the specific Menu Points will not be shown at all.

• The assignment for Aux [CH6] Output can be skipped by pressing the "Skip" button without teaching a channel for this function in case it is not used.
• Likewise, the assignment of the channel for internal governor can be skipped in case it is not needed or if you don‘t want to control the governor with a separate channel, e. g. if your transmitter does not provide enough free channels. By skipping the assignment the internal governor function will use a different operating mode that allows to control it by the throttle channel if you like. When used in an electric model the internal governor is controlled by the throttle channel in general. In this case the assignment can be skipped anyway, as it will have no effect.
• Finally, you can assign the channel that is used to engage the AttitudeControl/rescue stabilization (only available you've installed the PROEDITION Upgrade on your device). Again this can be skipped if not needed or if you don‘t want to use a separate channel or in case you have no more free channels left). AttitudeControl can still be used then. In this case the channel for the tail gyro gain is used to engage AttitudeControl or can be enabled separately using the Bank Switch feature. Please see the section about using AttitudeControl for further details.