Translations:Manuals:MBPlusFblV5:Parametermenu/8/en

From BEASTX Wiki
Revision as of 16:28, 15 January 2018 by FuzzyBot (talk | contribs) (Importing a new version from external source)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Rudder rate consistency (Point D)

At PARAMETER MENU point D the rudder rate consistency can be adjusted. This parameter comes into play when the tail gyro is operated in HeadingLock mode. It determines how hard the tail gyro tries to maintain a given rotation rate from the transmitter. If the value is set too low, pirouettes will be inconsistent during fast forward flight or in crosswind conditions and the helicopter will slowly drift on the vertical axis when in stationary hovering flight with crosswinds. If on the other hand the setting is too high, the tail gyro will respond delayed to fast directional changes and the rudder stick control feels very inprecise. Additionally the tail might make a slow bounce after stopping from a rotational movement and commute gently while hovering or flying around. So only adjust this parameter as high as necessary.

Parameter menu point D only adjusts some part of the tail gyro control loop. First of all, you must adjust the tail gyro gain in the transmitter and use it to switch the gyro to HeadingLock mode.

  • Before adjusting the rudder rate consistency always try to find the maximum amount of tail gyro gain by flying around and using the tail gyro in HeadingLock mode.
  • After adjusting the rudder rate consistency it might be necessary to readjust the tail gyro gain! Both parameters interact to each other.



Status-LED Rudder rate consistency
purple very low
red flashing low
red medium
blue flashing high
blue very high



Additional information
Please note that poor tail performance very often may be a sign of a stiff tail mechanics, slop in the tail linkage or an inadequate rudder servo! The tail rotor system in this case does not react as precise as necessary and hinders the tail gyro from working properly. If you cannot increase the rudder rate consistency further than “very low“ or “low“ without the tail rotor starting to slowly oscillate or bounce after doing a full stop, it is very likely that there is a mechanical issue. Also if on the other hand the tail does not turn constantly at high speeds or doesn't turn around at all, even with setting „very high“, again this may be due to a mechanical cause.

Make sure that the maximum blade pitch at the tail rotor neither is too large nor too small. A large pitch angle can lead to a stall of the tail rotor blades. Then the tail rotor produces hardly any thrust, similar to a very small angle. Also check the entire tail mechanics running smooth and without binding. Make sure that the rudder servo is strong enough and that it is supplied with sufficient power (long supply leads cause high voltage loss!). Check that the rudder servo does not get powerless at maximum servo deflection. This can happen if the pulse range of the servo is exceeded. The cause for lacking tail thrust also can be that the tail rotor blades are too small or too soft, or because the rotation speed of the tail rotor is too low!

To gain better tail gyro performance also check for correct servo horn length. If the tail gain in general is very low and the rudder tends to oscillate very easy move the linkage ball on the servo horn further inwards to the center. If on the other hand you have a very large amount of tail gain and the tail gyro still does not seem to be capable to hold the tail rotor in any flight condition, move the linkage ball on the servo horn further out from the center, to get faster response speed when the gyro needs to control the rudder.

Do not change the rudder rate consistency at menu point D in case the tail gyro does not hold well on abrupt directional changes. The rudder rate consistency doesn't compensate for sudden movements! In this case increase the gyro gain (if possible) or use the help of RevoMix feature (point F).