Translations:Manuals:AR7210FblV5:Radio System/7/en

Receiver binding

Prior to use you must bind the receiver to your Spektrum radio system. Please note that when you AR7210BX was already bound to your radio earlier, you must rebind when you connected a remote satellite afterwards (even when the satellite also was bound to your radio by another receiver)!

• Insert a Spektrum® “Bind Plug” at the [SYS] port of AR7210BX. In case the power is supplied exclusively at the [SYS] connection, to bind a Spektrum® satellite receiver the power supply must be provided temporarily through any of the other ports.
  

• Make sure the throttle on the radio is in lowest position. When bind procedure is finished the AR72100BX will store this position as Fail Safe position, which means that the throttle will moved here in case the radio link is broken before or in flight. Also this position will be used to prevent from powering up your radio with full throttle engaged by accident. So later onwards you will always have to make sure the throttle is at this low position when powering up radio and receiver (Smart Safe).
  

• Switch on the power supply now and initiate bind sequence on your radio system (usually by pressing and holding the bind button on the radio and powering up). After successful binding procedure the system will start with common initialization sequence. Additional note: It makes no difference if you pull off the “Bind Plug” during the binding process or leave it connected as you would expect from other Spektrum® receivers!

Watch out that the motor can not start accidentally when using the BEC of your speed controller to power the unit!