Translations:Manuals:AR7210FblV5:Setupmenu E/5/en

SETUP MENU E - Rudder limits

To adjust the servo limits move the rudder stick in one direction until the servo reaches the maximum end­point without any binding or stall. Release the rudder stick when correct position is reached. If you moved the servo too far you can steer the stick to the opposite direction and move the pitch slider a short way back. Also you can tap the stick briefly to only make minor adjustments. Once the correct endpoint has been found, don‘t move the rudder stick anymore and wait a second for the Status-LED to flash. This will indicate that the new position was stored. (If necessary you can change position as often as you want, but always wait until the Status-LED flashes when finished and proceeding to the next step!)

Now adjust the opposite direction. For this again use the rudder stick and hold it to move the servo/tail pitch slider into the other direction. Proceed as described to set the maximum endpoint and again wait until the position has been indicated with the flashing Status LED.

When both positions have been set skip to the next Menu Point F by pushing the button on the device briefly.