Manuals:MBUltraFblV5:ControlStyle/de: Difference between revisions

Die Steuerbewegungen vom Roll-, Nick- und Hecksteuerknüppel werden im MICROBEAST ULTRA als Drehrate umgesetzt. Wenn die Steuerknüppel in Mittenposition sind, heißt das folglich "den Heli nicht drehen". Andererseits ist nicht von vorne herein festgelegt, wie schnell sich der Heli bei einem bestimmten Steuerausschlag drehen soll. Hier kommt der Parameter '''Steuerverhalten''' in's Spiel, der die Möglichkeit bietet zwischen verschiedenen Drehraten und Steuerempfindlichkeiten zu wählen. Dies umfasst zum einen die maximale Drehrate des Helikopters und zum anderen, wie sensibel MICROBEAST PLUS auf Bewegungen von Roll-, Nick- und Hecksteuerknüppel im Bereich der Knüppelmittenstellung reagiert.<br />

{{WARNING_QUOTE|When using predefined control behaviors other than "transmitter" we do not recommend to additionally adjust control curves (Expo/Dual rates) in your transmitter as this will indefinably mix the preset curves of MICROBEAST ULTRA with the curves of the transmitter! Anyhow, if you only make small adjustments (e.g. slightly increasing the throw to increase rotation rate) this should be no problem.<br />

[[File:Warning.png|18px|sub]] If the tail gyro is operated in Normal-Rate mode the rudder stick directly controls the rudder servo instead of commanding a rotation rate to the gyro. In this mode the heli will turn as fast as it is determined by the rudder servo position and angle of attack of the rotor blades. The tail gyro does not monitor the rate of rotation. Therfore it is possible to get very high rotation rates and it is absolutely necessary to check how much pitch angle will be achieved at full rudder stick deflection at the tail rotor. Reduce the servo throw of the rudder servo by decreasing it on the remote control or limiting it on the MICROBEAST ULTRA to a reasonable level.}}<br />

=Setup with StudioX app=

When StudioX is connected to your MICROBEAST ULTRA, in the device overview main screen click the '''Parameter''' button. Then in the parameter settings click the "Next" button (->) in order to change to the topic ''Bank 1 - Control style''. Here you can select a given preset. In the advanced view (click gear symbol below) you will see the currently used maximum rotation rates and expo values for each control function aileron, elevator and rudder. The rate is measured in degrees per second, a value of 360 for example means your helicopter will make a full turn/rotation in one second, when you move the stick to full deflection. The expo value is specified in percent. 0% expo means that the stick input is influencing the output linearly. Usually this will make the control feel very sensitive and over reactive. By adding some expo you can soften the input around stick center position.<br />

When using the Bank Switch feature you can set different control styles for each bank. Click "Next" until you will see ''Bank 2 - Control style'' or ''Bank 3 - Control style'' and adjust as necessary or set the values similar to Bank 1 in case you don't like to have different styles on each bank.<br />

{{QUOTE|Please note that your custom values of Bank 1 will be changed/deleted when you select a preset control style in the PARAMETER MENU on the device (see above)!}}<br />