Manuals:BXFbl:Receiver N/de

Bei Einstellpunkt N des EMPFÄNGERMENÜs müssen wir die Failsafe- und Stop-Position für den Gaskanal einstellen. Sollte das Empfängersignal während des Betriebs unterbrochen werden, wird das Gasservo bzw. der Motorsteller automatisch in diese Position bewegt. Diese Position wird auch für andere Funktionen verwendet wie Governor, Heckmotor sowie insbesondere die automatische Gassperre während der Einschaltsequenz.

Failsafe
Die Failsafe Funktion ist nicht wirksam, wenn der Empfänger weiterhin Daten sendet, auch wenn die Funkverbindung unterbrochen ist. In diesem Fall muss die Failsafe Einstellung der Fernsteuerung verwendet werden. Bitte beachte hierzu das Handbuch zu Deiner Fernsteuerung. Um Unfälle zu vermeiden, muss der Motor bei Elektrohelis auf Voll-Stopp programmiert werden. Bei Verbrennermodellen wird das Gasservo auf Leerlaufstellung programmiert.

Automatic throttle lock
When the throttle is not in stop position during power up, the throttle will be held in failsafe position until you lower the throttle on the radio once. After finishing init sequence the Status LED will flash red/blue to indicate the throttle is locked!

Adjustment on the device

To teach the failsafe position at Menu Point N simply set the throttle channel on your remote control to the desired position and press the button briefly.

If you didn't connect anything to the throttle output and don't need throttle failsafe setting, press the button to complete setup anyway!

noframe

During failsafe setting the throttle output is enabled and can be controlled by the transmitter channel that is assigned to throttle function. This allows to check your throttle position in reality. When using electric models make sure the motor is disconnected from the ESC or the pinion is removed from the motor, so that it will not drive the model by accident.

Setup with StudioX

To teach the failsafe position choose "Proceed" when asked to teach the failsafe position and set the throttle channel on your remote control to the desired position. Then press Set to save the position. If you did not connect the throttle output and don't need throttle failsafe, press Cancel to complete setup!

<img class="ios" src="">

After function assignment click Proceed to start teaching the throttle failsafe position

<img class="ios" src="">

Move throttle to lowest position at which the motor is turned off

<img class="ios" src="">

Click Set to store the setting

'During failsafe setting the throttle output is enabled and can be controlled by the transmitter channel that is assigned to throttle function. This allows to check your throttle position in reality. When using electric models make sure the motor is disconnected from the ESC or the pinion is removed from the motor, so that it will not drive the model by accident.