StudioXm:Connection/en: Difference between revisions
Jump to navigation
Jump to search
Updating to match new version of source page |
Updating to match new version of source page |
||
Line 42: | Line 42: | ||
Then connect the USB/BLE Interface to the [SYS] port of your BEASTX device and power everything up. Click '''CONNECT''' to load the data from your device and to enter configuration menus. In case you are asked for the BLE2SYS pin code, this usually is 1111. If that doesn't work, please try 0000 or 1234.<br /> | Then connect the USB/BLE Interface to the [SYS] port of your BEASTX device and power everything up. Click '''CONNECT''' to load the data from your device and to enter configuration menus. In case you are asked for the BLE2SYS pin code, this usually is 1111. If that doesn't work, please try 0000 or 1234.<br /> | ||
<br /> | <br /> | ||
<div class=" | <br /> | ||
<img class="ios" src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09% | <html> | ||
<div class=" | <div class="ios-gallery-container"> | ||
<!-- Erstes Bild und Text --> | |||
<div class="ios-gallery-item"> | |||
<div class="ios-gallery-image"> | |||
<img src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09%20006.PNG" alt="Screenshot"> | |||
</div> | |||
<div class="ios-gallery-text"></div> | |||
</div> | |||
<div class="ios-gallery-item"> | |||
<div class="ios-gallery-image"> | |||
<img src="https://wiki.beastx.com/images/studiox/freakware%202019-07-09%20007.PNG" alt="Screenshot"> | |||
</div> | |||
<div class="ios-gallery-text"></div> | |||
</div> | |||
</div> | </div> | ||
</html> | |||
<br /> | |||
<br /> | <br /> | ||
{{QUOTE|When connection fails, <b>on the computer</b> once again check driver installation and port configuration as shown in [[StudioXm/en|the beginning]]. When your BLE2SYS is not found by the <b>smartphone/tablet</b>, check if the BLE2SYS it is operating properly: The blue LED must flash in short intervals. Note that by default the interface will switch off automatically after 30 seconds. So if you need too long time to initiate connection it may have been disabled. Disconnect it or cylce power and try again. <b>Sometimes it can be helpful to close the app completely, disconnect and reconnect the BLE2SYS and start over again!</b><br /> | {{QUOTE|When connection fails, <b>on the computer</b> once again check driver installation and port configuration as shown in [[StudioXm/en|the beginning]]. When your BLE2SYS is not found by the <b>smartphone/tablet</b>, check if the BLE2SYS it is operating properly: The blue LED must flash in short intervals. Note that by default the interface will switch off automatically after 30 seconds. So if you need too long time to initiate connection it may have been disabled. Disconnect it or cylce power and try again. <b>Sometimes it can be helpful to close the app completely, disconnect and reconnect the BLE2SYS and start over again!</b><br /> |