Manuals:BXFbl:Hardware Installation/de: Difference between revisions
Shornstein (talk | contribs) Created page with "Befestige deine BEASTX-Einheit mit einem der mitgelieferten 3M®-Gyropads an einer möglichst vibrationsarmen Position an deinem Hubschrauber, wie zum Beispiel der Gyro-Plattf..." |
Shornstein (talk | contribs) Created page with "Das BEASTX-System kann '''flach oder aufrecht''' am Hubschrauber befestigt werden:<br /> {| cellspacing="20" style="text-align: center; width: 300px; font-size: 70%;" |- | col..." |
||
| Line 6: | Line 6: | ||
<br /> | <br /> | ||
Das BEASTX-System kann '''flach oder aufrecht''' am Hubschrauber befestigt werden:<br /> | |||
{| cellspacing="20" style="text-align: center; width: 300px; font-size: 70%;" | {| cellspacing="20" style="text-align: center; width: 300px; font-size: 70%;" | ||
|- | |- | ||
Revision as of 13:21, 21 May 2024
Befestige deine BEASTX-Einheit mit einem der mitgelieferten 3M®-Gyropads an einer möglichst vibrationsarmen Position an deinem Hubschrauber, wie zum Beispiel der Gyro-Plattform oder der Empfänger-Plattform. Du musst möglicherweise eine andere Art von Befestigungspad wählen, abhängig vom Vibrationsmuster deines Hubschraubers.
Das BEASTX-System kann flach oder aufrecht am Hubschrauber befestigt werden:
|
|
Pay attention that the edges of the housing of your BEASTX unit are all parallel with the corresponding rotational axes of the helicopter!
|
Make sure that the mounting platform is perpendicular to the main shaft! On the other hand it's not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important that the system is placed in parallel to the ground or not.
MICROBEAST PLUS / MICROBEAST ULTRA
The servo connector pins must always point towards the front or rear of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.
|
|
| ||
 flat, cover on top, servo connectors showing to front |
 flat, cover showing to bottom, servo connectors showing to front |
 upright, button at top, servo connectors showing to front |
 upright, button at bottom, servo connectors showing to front |
 flat, cover on top, servo connectors showing to rear |
 flat, cover showing to bottom, servo connectors showing to rear |
 upright, button at bottom, servo connectors showing to rear |
 upright, button at top, servo connectors showing to rear |
NANOBEAST
The pins of SYS and DI1 must always point towards the front or rear of the helicopter. The white servo pinboard must always be positioned at a right angle to flight direction.
|
|
| ||
 flat, cover on top, servo connectors showing to front |
 flat, cover showing to bottom, servo connectors showing to front |
 upright, LED at top, servo connectors showing to front |
 upright, LED at bottom, servo connectors showing to front |
 flat, cover on top, servo connectors showing to rear |
 flat, cover showing to bottom, servo connectors showing to rear |
 upright, LED at bottom, servo connectors showing to rear |
 upright, LED at top, servo connectors showing to rear |