SETUPMENÜ M - Zyklische Wegbegrenzung

From BEASTX Wiki
Revision as of 10:49, 1 March 2023 by Shornstein (talk | contribs) (Created page with "{{WARNING_QUOTE| Versuche immer soviel Steuerweg wie möglich zu erreichen und stelle die Wegbegrenzung nicht zu stark ein. Verwende die Wegbegrenzung nicht dazu, um das Flugv...")
Jump to navigation Jump to search


At SETUP MENU point M we can limit the servo movement so that the servos will not come out of the possible range of action and cause jamming of the linkages or swashplate. But ideally we want to limit as less as possible, so that the system can control the helicopter without any restrictions! For the ease of use, the limiting is only one value to adjust but which will affect all servos and all possible directions at once, especially when steering into the corners.

The color of the Status LED gives some indication whether you rotorhead geometry is well suited for flybarless usage or not. Ideally the Status LED on the device should be blue after you've adjusted the limit properly. If it isn't, this means your servos do not make very large deflections and probably you do not have very much cyclic pitch left in the extreme positions. This can for example cause pitching up when flying with high speed and lots of collective input, inprecise flying in general or it can cause you heli not to have equal rotations rates, accelerate slowly or not being able to reach high rotation rates at all.

Status-LED Servo limit
purple not good
red OK
blue perfect!



Versuche immer soviel Steuerweg wie möglich zu erreichen und stelle die Wegbegrenzung nicht zu stark ein. Verwende die Wegbegrenzung nicht dazu, um das Flugverhalten des Helis zu beeinflussen, insbesondere nicht um den Pitchwinkel oder die Drehraten zu verändern. Dafür ist die Wegbegrenzung nicht gedacht!



Adjustment on the device

  • At SETUP MENU point M carefully move pitch, aileron and elevator all at once and into all possible positions and check if there is some point where the servos get jammed.
  • By rudder stick input you can increase/decrease the amount of maximum servo throw/servo limit (left = decrease throw, right = increase throw).
  • Make sure the throw is as high as possible.
  • If you change the collective pitch at SETUP MENU point L at a later time, check and readjust the cyclic limit if necessary!



Setup with StudioX app

  • Carefully move pitch, aileron and elevator all at once and into all possible positions and check if there is some point where the servos get jammed.
  • Increase/decrease the amount of maximum servo throw/servo limit by using the + and - buttons and the dial.
  • Make sure the value is as high as possible.
  • If you change the collective pitch at SETUP MENU point L at a later time, check and readjust the cyclic limit if necessary!