Changes

<p>To get into the Receiver menu press the button on MICROBEAST PLUS and hold it down before(!) and while turning on the receiver power supply. The yellow Menu-LEDs start to cycle immediately. When you release the button, Menu LED A will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.</p>

<p>To get into the Receiver menu press the button on MICROBEAST PLUS and hold it down before(!) and while turning on the receiver power supply. The yellow Menu-LEDs start to cycle immediately. When you release the button, Menu LED A will be flashing and the color of the Status LED will indicate the receiver type that is selected at the moment.</p>

[[File:Receiver_setup_1.png|x180px|none]]

[[File:Receiver_setup_1.png|x180px|none]]

{{WARNING_QUOTE|Note that in the first menu points of Receiver setup menu no control signal is emitted on [CH5] Output of MICROBEAST PLUS, in case you are using a single-line receiver. At [[Manuals:MB_Plus:Receiver_setup_menu_N|menu point '''N''' (Throttle failsafe setting)]] the output is activated though to check throttle position! '''If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the engine!''' For a heli with combustion engine you should remove the servo horn from the throttle servo to avoid linkage binding or breaking the servo horn.}}<br />

{{WARNING_QUOTE|Note that in the first menu points of Receiver setup menu no control signal is emitted on [CH5] Output of MICROBEAST PLUS (in case you are using a single-line receiver). At Menu Point '''N''' (Throttle failsafe setting) the output is activated though to check throttle position! '''If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the motor!''' For a heli with combustion engine you should remove the servo horn from the throttle servo to avoid linkage binding or breaking the servo horn.}}<br />

<br />

<br />