7,261
edits
Changes
Jump to navigation
Jump to search
Line 3:
Line 3: + + Line 22:
Line 24: + + + +
Manuals:MBPlusFblV52:Governormenu A/en (view source)
Revision as of 13:43, 27 April 2021
, 3 years agoUpdating to match new version of source page
__TOC__
__TOC__
<br />
<br />
=Adjustment on the device=
At GOVERNOR MENU point A there is nothing to adjust. Here you will only get some visual indication to see if the hardware is working so far and in general if there is a usable rpm signal.<br />
At GOVERNOR MENU point A there is nothing to adjust. Here you will only get some visual indication to see if the hardware is working so far and in general if there is a usable rpm signal.<br />
<br />
<br />
{{QUOTE|If the Status-LED on the MICROBEAST PLUS does not light up as described please double check the wiring. Particularly pay attention whether the power wires of the sensor are of correct polarity (on some sensors the wire colors do not match the usual standard!). If you have a magnetic sensor check if the magnets are installed with the correct polarity and if they are passing the front of the sensor close enough. Using a crankshaft sensor make sure that the sensor is mounted close enough to the frame accordingly.}}<br />
{{QUOTE|If the Status-LED on the MICROBEAST PLUS does not light up as described please double check the wiring. Particularly pay attention whether the power wires of the sensor are of correct polarity (on some sensors the wire colors do not match the usual standard!). If you have a magnetic sensor check if the magnets are installed with the correct polarity and if they are passing the front of the sensor close enough. Using a crankshaft sensor make sure that the sensor is mounted close enough to the frame accordingly.}}<br />
<br />
=Setup with StudioX=
From the overview open the Menu '''Governor Setup'''. There go to the sub menu ''Governor radio setup'' and "Activate" the ''Sensor test''. The label will light up and red or blue color as described above. With an electric model also you can read the motor speed/head speed in order to verify the setup of main gear ratio and signal divider done at the ''Governor basic setup''. When finished click ''Exit''.<br >
<br />
<br />