Bureaucrats, Administrators, translate-proofr
15,475
edits
Changes
Jump to navigation
Jump to search
Line 38:
Line 38: − Line 45:
Line 44: − + − + Line 54:
Line 53: − + − + + − + + + +
Manuals:BXFbl:Radio Setup:Futaba SBUS (view source)
Revision as of 14:21, 27 March 2024
, 1 month agono edit summary
(Picture MBPLUS)<br />
(Picture MBPLUS)<br />
<br />
<br />
(Picture Nanobeast)<br />
(Picture Nanobeast)<br />
<br />
<br />
<br />
<br />
(Picture MBPLUS)
(Picture MBPLUS)<br />
<br />
(Picture Nanobeast)<br />
(Picture Nanobeast)<br />
<br />
<br />
For bi-directional telemetry connect your SBUS2 signal wire either to the SYS port or to the DI2 port of your MICROBEAST ULTRA. In both cases it is mandatory to add a pull-down 4,7kOhm resistor between signal line and ground (minus). When using the DI2 port, also you need an adapter from standard servo connector to 5-pin JST as shown below.
For bi-directional telemetry connect your SBUS2 signal wire either to the SYS port or to the DI2 port of your MICROBEAST ULTRA. In both cases it is mandatory to add a pull-down 4,7kOhm resistor between signal line and ground (minus). When using the DI2 port, also you need an adapter from standard servo connector to 5-pin JST as shown below.
(Picture Resistor)
(Picture Resistor)<br />
(Picture SYS)
(Picture SYS)<br />
<br />
(Picture Resistor)
(Picture Resistor)<br />
(Picture DI2)<br />
(Picture DI2)<br />
<br />
The ESC or throttle servo is connected at IO1 port. If needed the telemetry data line from the ESC is connected to the IO2 port.<br />
<br />
<br />
<br />
<br />