7,241
edits
Changes
Jump to navigation
Jump to search
Line 13:
Line 13: − {{SHORT_QUOTE|width = 90|[[File:Warning.png|20px|sub]] '''Pay attention that the edges of the housing of your BEASTX unit are all parallel with the corresponding rotational axes of the helicopter!''' Make sure that the mounting platform is perpendicular to the main shaft!<br />+ − <br />It is not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important if the system is placed in parallel to the ground or not.}}<br />+ Line 30:
Line 30: + + + Line 74:
Line 77: +
Manuals:BXFbl:Hardware Installation/de (view source)
Revision as of 11:15, 24 April 2024
, 18 days agoUpdating to match new version of source page
<br />
<br />
'''Pay attention that the edges of the housing of your BEASTX unit are all parallel with the corresponding rotational axes of the helicopter!'''<br />
<br />
<div class="noprint">
<div class="noprint">
</div>
</div>
Make sure that the mounting platform is perpendicular to the main shaft! On the other hand it's not important that the unit is directly placed on all the rotation axis (which is nearly impossible). Also it's not important that the system is placed in parallel to the ground or not.<br />
<br />
<br />
<br />
<br />
<br />
'''MICROBEAST PLUS / MICROBEAST ULTRA'''<br />
'''MICROBEAST PLUS / MICROBEAST ULTRA'''<br />
<br />
The '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.<br />
The '''servo connector pins must always point towards the front or rear''' of the helicopter. The small white sensor pinboard on the side must always be in line with flight direction.<br />
<br />
<br />
'''NANOBEAST'''<br />
'''NANOBEAST'''<br />
<br />
The '''pins of SYS and DI1 must always point towards the front or rear''' of the helicopter. The white servo pinboard must always be positioned at a right angle to flight direction.<br />
The '''pins of SYS and DI1 must always point towards the front or rear''' of the helicopter. The white servo pinboard must always be positioned at a right angle to flight direction.<br />
<br />
<br />