Changes

For Autorotation bail out set the throttle curve to a flat 10%. The Status LED should light up in "blue" when Autorotation switch is enabled.

For Autorotation bail out set the throttle curve to a flat 10%. The Status LED should light up in "blue" when Autorotation switch is enabled.

That's it. Switch back to your normal mode (motor off!) and proceed with the following steps E, F, G, H as described in the MICROBEAST PLUS ProEdition manual. After exiting the menus you can do a little bench test. When switching to idle up the motor should start to run slowly, then after a short time of stabilization the rpm will increase more forcefull. If it takes very long time (a few seconds) until the motor starts to initially run, you may readjust the throttle low point at Governor menu point B. Typically the distance between motor off and motor start position is too large then.  

That's it. Switch back to your normal mode (motor off!) and proceed with the following steps E, F, G, H as described in the MICROBEAST PLUS ProEdition manual. After exiting the menus you can do a little bench test. When switching to idle up the motor should start to run slowly, then after a short time of stabilization the rpm will increase more forceful (it is not unusual that without rotor blades or with main gear removed beacuse of the unloaded condition the motor may run erratic or the rpm may pump a little bit during spoolup!). If it takes very long time (a few seconds) until the motor starts to initially run, you may readjust the throttle low point at Governor menu point B. Typically the distance between motor off and motor start position is too large then.  

</translate>

</translate>