Changes

</gallery>

</gallery>

{{WARNING_QUOTE|If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the engine! For a heli with combustion engine you should remove the servo horn from the throttle servo. Note that in the first menu points of Receiver setup menu no control signal is emitted on [CH5] output of MICROBEAST PLUS, in case you are using a single-line receiver. At menu point '''N''' (Throttle failsafe setting) the output is activated though to check throttle position!

{{WARNING_QUOTE|If you use a speed controller with BEC, disconnect the motor to avoid unintentional starting of the engine! For a heli with combustion engine you should remove the servo horn from the throttle servo. Note that in the first menu points of Receiver setup menu no control signal is emitted on [CH5] output of MICROBEAST PLUS, in case you are using a single-line receiver. At menu point '''N''' (Throttle failsafe setting) the output is activated though to check throttle position!}}

</translate>

</translate>