Changes

<br />

<br />

Then adjust the servo limit for the other direction. Drive the tail pitch slider by using the rudder stick to the other maximum endpoint and then release the rudder stick. After a short moment, the color of the Status-LED should start flashing followed by lightning steady purple (mix of red and blue) indicating that the servo endpoint adjustment is complete.<br />

Then adjust the servo limit for the other direction. Drive the tail pitch slider by using the rudder stick to the other maximum endpoint and then release the rudder stick. After a short moment, the color of the Status-LED should start flashing followed by lightning steady purple (mix of red and blue) indicating that the servo endpoint adjustment is complete.<br />

[[Image:Setupmenu_E_left.png|600px|none|border]]<br />

[[Image:Setupmenu_E_left.png|600px|none|border]]<br />

<br />

<br />

{{QUOTE|[[Image:Warning.png|18px|sub]] Pay attention that the steered direction of your rudder stick corresponds to the direction your helicopter should turn. If this is not the case, use your transmitter‘s servo reversing function for the rudder stick. If you‘re not sure in which direction the helicopter should rotate consult the manual for your helicopter.<br />

{{QUOTE|[[Image:Warning.png|18px|sub]] Pay attention that the steered direction of your rudder stick corresponds to the direction your helicopter should turn. If this is not the case, use your transmitter‘s servo reversing function for the rudder stick. If you‘re not sure in which direction the helicopter should rotate consult the manual for your helicopter.<br />

<br />

<br />

[[Image:Warning.png|18px|sub]]<br />

[[Image:Warning.png|18px|sub]] If the Status-LED does not light or lights in an unexpected color, the servo throw is obviously too small. In this case mount the linkage ball of the tail linkage rod further inward on the servo horn. This ensures that the tail gyro of MICROBEAST PLUS will perform in the best way and that enough servo resolution is available.<br />

<br />[[Image:Warning.png|18px|sub]] By (re-)adjusting tail rotor endpoints the servo center trim will be reset to zero (in case it has been changed at [[Manuals:MB_Plus:Parametermenu_A|Parameter menu point '''A''']]).}}

If the Status-LED does not light or lights in an unexpected color, the servo throw is obviously too small. In this case mount the linkage ball of the tail linkage rod further inward on the servo horn. This ensures that the tail gyro of MICROBEAST PLUS will perform in the best way and that enough servo resolution is available.<br />

<br />[[Image:Warning.png|18px|sub]] By (re-)adjusting tail rotor endpoints the servo center trim will be reset to zero (in case it has been changed at [[Manuals:MB_Plus:Parametermenu_A|Parameter menu point '''A''']]).}}<br />

<br />

<br />

<br />

<br />