Changes

===Nitro===

===Nitro===

In „nitro“ mode the throttle servo can be controlled entirely via the throttle channel of the remote control as long as the RPM Governor is switched off. Only when the RPM Governor is switched on, this will control the throttle servo to spool up the rotor to the desired speed (if this is not yet reached) and ensure that the rotor speed is maintained during the flight. The manual throttle control is especially necessary to start and warm up the engine as well as to stop the engine after flight. Also some model engines react very sensitive in the lower throttle sector and too abrupt engagement can cause the engine to quit, i.e. when the clutch is not fully engaged and/or the rotor is not yet turning. In this case a manual throttle control can be of advantage as the pilot can run the engine to speed by hand before control is passed over to the RPM Governor.<br />

In '''nitro''' mode the throttle servo can be controlled entirely via the throttle channel of the remote control as long as the RPM Governor is switched off. Only when the RPM Governor is switched on, this will control the throttle servo to spool up the rotor to the desired speed (if this is not yet reached) and ensure that the rotor speed is maintained during the flight. The manual throttle control is especially necessary to start and warm up the engine as well as to stop the engine after flight. Also some model engines react very sensitive in the lower throttle sector and too abrupt engagement can cause the engine to quit, i.e. when the clutch is not fully engaged and/or the rotor is not yet turning. In this case a manual throttle control can be of advantage as the pilot can run the engine to speed by hand before control is passed over to the RPM Governor.<br />

<br />

<br />

Depending on whether an auxiliary channel was assigned to control the RPM Governor in Receiver setup menu or not, the RPM Governor is either controlled separately via this channel or you can control both RPM Governor and throttle servo alone by using the throttle channel of the transmitter. In general the adjustable throttle range in „nitro“ mode is 2400 rpm/min. The lowest head speed to govern is 600 rpm/min, the maximum head speed is 3000 rpm/min.<br />

Depending on whether an auxiliary channel was assigned to control the RPM Governor in Receiver setup menu or not, the RPM Governor is either controlled separately via this channel or you can control both RPM Governor and throttle servo alone by using the throttle channel of the transmitter. In general the adjustable throttle range in „nitro“ mode is 2400 rpm/min. The lowest head speed to govern is 600 rpm/min, the maximum head speed is 3000 rpm/min.<br />