Line 127: |
Line 127: |
| [[File:Mb_config_dlg.png|200px|thumb|none]] | | [[File:Mb_config_dlg.png|200px|thumb|none]] |
| ==Interface Einstellungen (Serial Port Control)== | | ==Interface Einstellungen (Serial Port Control)== |
− | By default the MICROBEAST PLUS plug-in will continuously try to query all serial interfaces (the USB2SYS/SPMA3030-Interface is a serial interface) to check if a MICROBEAST PLUS is connected somewhere.<br />
| + | Standardmäßig versucht das MICROBEAST PLUS Plug-In über sämtliche vorhandenen seriellen Schnittstellen ein MICROBEAST PLUS zu erreichen (das USB2SYS/SPMA3030-Interface bildet eine serielle Schnittstelle). Manchmal kann es notwendig sein bestimmte Schnittstellen von der Suche auszuschließen, z. B. wenn eine Schnittstelle das Plug-In blockiert. Hierfür gibt es zwei Möglichkeiten |
− | Sometimes it is useful to limit the ports that the plug-in is trying to query, i.e. in case a port is blocking the plug-in. Therefore you can choose from one of the following options:
| + | * Ausschluss der angewählten Ports (2Use all ports, except those selected") |
− | * Use all ports, except those selected | + | * Suche nur auf den angewählten Ports ("Only use selected ports") |
− | * Only use selected ports | + | Wählen Sie aus ob das Ein- oder Ausschlusskritierium angewendet werden soll und markieren sie den Port der verwendet bzw. der ausdrücklich nicht verwendet werden soll.<br /> |
− | Use the entries in the list below to refine your selection. The plug-in will only try to query ports which match the selected rule.<br />
| + | ==Gerätesuchintervall (Device Discovery)== |
− | ==Device Discovery== | + | Dieser Wert bestimmt in welchen Zeitabständen die Gerätesuche wiederholt wird. Normalerweise sollte der voreingestellte Wert gut funktionieren.<br /> |
− | This specifies the interval time which is used to try identifying newly connected devices. This should not be modified if the mechanism is working properly.<br />
| |
| <br /> | | <br /> |