Basic functionality

From BEASTX Wiki
Revision as of 13:57, 30 August 2018 by Shornstein (talk | contribs)
Jump to navigation Jump to search



Please note that StudioX 3/StudioXm can be used in combination with MICROBEAST PLUS, AR7120BX and NANOBEAST only. For older devices like MICROBEAST, AR7200, AR7300 you must use StudioX Version 2.2.x. Instructions for the old StudioX can be found by clicking here.



BEASTX flybarless system

When connection to your BEASTX device is established wait until the data is loaded from the device and initialization sequence is finished. At first the system will calibrate to the radio system, Menu LEDs H to N will cycle up and down at the device (MICROBEAST PLUS/AR7210BX) and you can read "Radio init" in the opening overview screen. During this time do not move the sticks on your radio as the system is learning the stick mid positions. In the second step the device checks if the sensors are working correctly and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down (MICROBEAST PLUS/AR7210BX) and you can read "Sensor init" in the opening overview screen. During this time do not move the helicopter. When initialization is completed the Status LED will change to blue or purple color indicating the current gyro mode and you can read the gyro gain and mode in the app. If you can't get through the initialization sequence either because LEDs A-G or LEDs H-N don't stop cycling please read the FAQ and do the CONTROL SETUP first.


BLE2SYS Configuration