Translations:Manuals:AR7210FblV5:Governormenu B/2/en

GOVERNOR MENU point B is used to set the lowest throttle position. This is needed as the system must know the motor starting point for the automatic spool up of the rotor when enabling the governor from standing still.

Using an electric model bring the throttle stick to the position at which the motor is just about to start. If the stick throw has been adjusted as described at GOVERNOR MENU point A (or the speed controller has been programmed to the stick throws), the necessary throttle position should be achieved at the lowest position of the throttle stick. Some speed controllers provide a special mode that allows for a quick start-up in case of aborting an autorotation landing. Here you have a larger area between the actual „motor off“ position of the speed controller and the point at which the motor starts. Also in this case move the throttle stick to the point at which the motor is just before to start, so that the AR7210BX can determine the effective throttle range correctly.

With a nitro/gasser model bring the throttle stick to idle position or a slightly increased idle position (not „motor off“!) so the AR7210BX can determine the effective throttle range in the next step. In case you've not assigned an auxiliary channel to control the Governor when doing the setup in RECEIVER MENU, this position additionaly will be used as idle position when performing autorotation maneuvers. So you should set the throttle as high as necessary here that the motor will maintain a stable run and doesn‘t quit in autorotation.

Watch Out! Output [THR] can be directly controlled by the throttle stick.