Translations:Manuals:MBPlusFblV52:TailMotor/4/en

From BEASTX Wiki
Jump to navigation Jump to search

Governor menu

Now briefly open the Governor menu and check the settings:

  • For the Logo 200/OMP M2 heli we use the "Electric" Governor with signal divider "12" and gear ratio "1.0". If using a different heli you may change this as needed. Of course, it's also possible to do without Governor function, i.e. when your heli has a speed controler with decent internal heli governor.
  • On the next page teach idle position, which usually must be the same position as the Failsafe setting for Motor off.
  • Adjust full throttle accordingly. For the Logo 200/OMP M2 heli just give it full throttle; +100% in the transmitter should be fine.
  • Then go to "Transmitter test" and adjust the throttle curves in the radio to straight lines or setup the throttle switch so that the desired speeds are displayed. For the Logo 200/OMP M2 heli we recommend a speed of 3500rpm for Idle 1 and 4500rpm for Idle 2.
Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:MBPlusFblV52:TailMotor/4/en&oldid=22322"