Translations:Manuals:MBPlusFblV5:Setupmenu H/3/en

Adjustment on the device

Initially when the trimming is 0 on all servos the Status LED will be off. Attach the servo horns on the servos at their true center position, so that you get roughly equal throws to both direction. Mount the servo horns so that they form a 90 degrees angle to the linkage rod as close as possible. Then in the next step you electronically fine trim every single servo‘s center position, as usually mounting the servo horn at exact 90 degrees will not work out perfectly depending on the servo‘s gear train and the servo horn.

By tapping the stick for aileron you can select one servo after another. Every color of the Status-LED is corresponding to a specific servo channel that is indicating its selection by a short up and down move. Use the rudder stick to change the servo trimming/adjust the center position. You can switch back and forth between the servos as often as you need.

Status-LED	Servo trim
off	all zero
purple	CH1 – elevator servo
red	CH2 – aileron(1) servo
blue	CH3 – aileron(2) / pitch servo (mCCPM)
red/blue	CH7 – elevator servo(2) (90° eCCPM only)