StudioXm:Overview/de: Difference between revisions

From BEASTX Wiki
Jump to navigation Jump to search
Created page with "StudioXm:Overview"
 
Created page with "{{MINIQUOTE|Bitte beachte, dass StudioX 3/StudioXm nur mit MICROBEAST PLUS, AR7120BX und NANOBEAST verwendet werden kann. Ältere Geräte wie MICROBEAST, AR7200, AR7300 sind n..."
Line 5: Line 5:
<br />
<br />


{{MINIQUOTE|Please note that StudioX 3/StudioXm can be used in combination with MICROBEAST PLUS, AR7120BX and NANOBEAST only. For older devices like MICROBEAST, AR7200, AR7300 you must use StudioX Version 2.2.x.  Instructions for the old StudioX can be found by [[StudioX/en|clicking here]].}}<br />
{{MINIQUOTE|Bitte beachte, dass StudioX 3/StudioXm nur mit MICROBEAST PLUS, AR7120BX und NANOBEAST verwendet werden kann. Ältere Geräte wie MICROBEAST, AR7200, AR7300 sind nur mit der StudioX Version 2.2.x kompatibel. Eine Anleitung für diese ältere StudioX Version findest Du [[StudioX/en|unter diesem Link]].}}<br />
<br />
<br />



Revision as of 13:47, 30 August 2018



Bitte beachte, dass StudioX 3/StudioXm nur mit MICROBEAST PLUS, AR7120BX und NANOBEAST verwendet werden kann. Ältere Geräte wie MICROBEAST, AR7200, AR7300 sind nur mit der StudioX Version 2.2.x kompatibel. Eine Anleitung für diese ältere StudioX Version findest Du unter diesem Link.



BEASTX flybarless system

When connection to your BEASTX device is established wait until the data is loaded from the device and initialization sequence is finished. At first the system will calibrate to the radio system, Menu LEDs H to N will cycle up and down at the device (MICROBEAST PLUS/AR7210BX) and you can read "Radio init" in the opening overview screen. During this time do not move the sticks on your radio as the system is learning the stick mid positions. In the second step the device checks if the sensors are working correctly and learns the sensor rest positions. Here Menu LEDs A to G will cycle up and down (MICROBEAST PLUS/AR7210BX) and you can read "Sensor init" in the opening overview screen. During this time do not move the helicopter. When initialization is completed the Status LED will change to blue or purple color indicating the current gyro mode and you can read the gyro gain and mode in the app. If you can't get through the initialization sequence either because LEDs A-G or LEDs H-N don't stop cycling please read the FAQ and do the CONTROL SETUP first.

Note that during initialization pressing the button has no significant effect and you will not be able to enter any menu.


BLE2SYS Configuration