Manuals:AR7210FblV5:Governormenu C/de

Bei Einstellpunkt C wird die maximale Gasposition festgelegt. Im Modus "Verbrenner" wird der Ausgang [THR] direkt vom Motorkanal/Gassteuerknüppel angesteuert. Im Modus "Elektro" ist der Ausgang gesperrt und wird auf der niedrigsten Position gehalten. So kann die Vollgasposition gesetzt werden, ohne dass der Motor mit hoher Drehzahl läuft. Ansonsten gibt es an diesem Einstellpunkt keine Unterschiede zwischen Elektro- und Verbrennerheli!

Adjustment on the device

Move the throttle stick to full throttle position. The Status-LED must light up in blue color. This means that a new valid throttle position has been detected. If the Status-LED lights up in red the distance between the lowest throttle position and the full throttle position is too small. Since this will have a negative effect on the control behavior of the system, this throttle position can not be used. In this case check the setting of the transmitter and the programming of the speed controller or readjust throttle servo, carburetor position and throttle linkage rod. If necessary, set the lowest throttle position at menu point B again.

Similar to menu point B the Status-LED is off when entering menu point C. As long as you do not move the throttle stick, the currently stored position will not be changed. So you can skip menu point C by a brief push of the button without changing the throttle position when performing subsequent adjustments in Setup menu or Governor setup menu. Conversely this means that you need to move the throttle stick at menu point C at least once to change the current full throttle position!

Setup with StudioX

When performing the setup with StudioX, you will see the actual internal throttle value in the app. Usually this will be something around +-1000 when the throttle is at maximum position. Push the SET button in order to store the value shown as maximum throttle value for the headspeed governor.