Difference between revisions of "Translations:Manuals:AR7210FblV5:Setupmenu A/1/en"

From BEASTX Wiki
Jump to navigation Jump to search
(Importing a new version from external source)
 
(No difference)

Latest revision as of 12:56, 14 June 2018

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (Manuals:AR7210FblV5:Setupmenu A)
{{DISPLAYTITLE:SETUP MENU A - Device orientation|noerror}}
{{TOC_AR7210V5|Manuals:AR7210FblV5:Setupmenu_intro/en|Manuals:AR7210FblV5:Setupmenu_B/en|SETUPMENU}}
__TOC__
<br />
The AR7210BX receiver can be mounted in nearly all possible orientations. The only restriction is that the servo connection terminal has to point in or against flying direction and the egdes of the unit must be aligned in parallel to the rotation axis.<br />
<br />
Translation{{DISPLAYTITLE:SETUP MENU A - Device orientation|noerror}}
{{TOC_AR7210V5|Manuals:AR7210FblV5:Setupmenu_intro/en|Manuals:AR7210FblV5:Setupmenu_B/en|SETUPMENU}}
__TOC__
<br />
The AR7210BX receiver can be mounted in nearly all possible orientations. The only restriction is that the servo connection terminal has to point in or against flying direction and the egdes of the unit must be aligned in parallel to the rotation axis.<br />
<br />

AR7210BX V5

1. Introduction

2. Hardware installation

3. Radio system

4. Basic setup
Device orientation
Swashplate frequency
Rudder pulse width
Rudder frequency
Rudder control
Swash mixing
Servo trim
Servo directions
Cyclic throw
Collective pitch
Servo limit
Cyclic directions
5. Headspeed Governor
Activating the governor
Sensor test mode
Throttle low position
Throttle high position
Transmitter setup
Signal divider
Main gear ratio
6. Additional settings
Trimming
Control style
Special parameters
Gains

7. AttitudeControl (Self leveling)

8. Bank Switching

9. Factory reset

10. Firmware update

← →


The AR7210BX receiver can be mounted in nearly all possible orientations. The only restriction is that the servo connection terminal has to point in or against flying direction and the egdes of the unit must be aligned in parallel to the rotation axis.

Retrieved from "https://wiki.beastx.com/index.php?title=Translations:Manuals:AR7210FblV5:Setupmenu_A/1/en&oldid=15377"